Motion Cabinet Replacement

Simulation and Control Technologies, Inc. has developed a Motion Cabinet Replacement for existing obsolete or problematic Motion Systems. This update provides a seamless, high performance, cost effective solution for the replacement of obsolete electronics with state of the art PC based digital controllers. This solution is intended for simulators that are burdened with a high level of maintenance to meet FAA level C, or D standard. The concept is to eliminate all the analog interface circuitry or obsolete electronics and drive the hydraulic Legs directly from our own EtherCAT based remote I/O board within the new Motion Control Software. The obsolete analog servo or interface electronics are replaced with software running at a 2KHz rate. The update makes for a more maintainable system for both the hardware maintenance staff and for the engineering staff.

Software

Digital Inner and Outer Loops

Cost Effectiveness

Minimal Down Time

In-house testing and development: utilizing our in-house motion test plaforms. Non-intrusive on-site installation performed during maintenance periods leaving the simulator available for scheduled training everyday until final test and acceptance.

User Friendly

Seamless approach maintains present simulator hydraulic motion, safety interlocks, and IOS functions while providing extensive diagnostic capabilities

Contact us today if you have questions or are ready to get started with a Motion Cabinet Replacment

Copyright © 2017. All rights Reserved.
Simulation and Control Technologies   |   42 Corbettsville Road   |   Conklin, NY Phone (607) 722-3450   |   Fax: (607) 722-3486